This product can improve the grinding efficiency and reduce abrasive wear. The work of protection and lubrication, improve the workpiece surface finish and brightness. According to a variety of materials need to roll the workpiece, developed into a different grinding fluid for users to choose.

 Grinding fluid role and use

 1, grinding fluid, the amount of water added

The addition amount of the grinding liquid is determined by the water quality and the cutting of the cuttings, and the amount of hard cutting is large, and the amount of the polishing solution to be added is more. As the centrifugal mill in the same time the amount of chips, so the amount of grinding fluid should be more. In general, the addition of the grinding fluid of the spiral vibratory grinding mill is 6-10% of the volume of the grinding tank. Then, 60-100 g of each grinding is added, while the 30L centrifugal grinding machine has only 7.5 liters per volume, Utilization rate of 55%, each drum plus 20 grams, glossy light when the amount of increase. Water in the workpiece surface light in the buffer, the role of cleaning. The amount of water added, the buffer effect, the workpiece deformation is reduced, and can reduce the workpiece surface roughness. Spiral vibratory grinding machine water added volume of 3-5% of the volume. The amount of water added to the centrifugal mill can be 4-5 cm on the mixture surface.

2, the role of grinding fluid

A small amount of the grinding liquid is poured into the drum and then stirred by water and adhered to the surface of the part and the abrasive at the time of finishing. The effect is as follows:

① softening effect: that is, the metal surface oxide film chemical effect, so that softening, easy to remove from the surface grinding to improve the grinding efficiency.

② lubrication: like grinding lubricants, like grinding parts and metal parts from the lubrication between, so as to get smooth surface.

③ washing effect: like detergent, can remove the metal parts of the surface of the oil.

④ anti-rust effect: grinding parts after processing, not cleaned in a short time before a certain anti-rust effect. ⑤ buffer effect: in the finishing operation, stirring with water, will ease the impact between the parts.